This article has been discontinued, it is no longer available and will not be renewed.

Latex Contact Cement by Dura Pro


Latex Contact Cement AC 2389 is a water based glue specially designed for the bonding of decorative laminates, polyurethane foam, polystyrene foam, and fabrics to wood, plywood or particle board.

Latex Contact Cement features an important open-time and also a good adherence under low pressure. The Latex Contact Cement resists to shearing and peeling.

  • Water base adhesive
  • High coverage
  • Low odor – Non flammable


Directions of use

Preparation : Stir well until uniform consistency. Adhesive and materials (unwrapped) must be at room temperature (20°C) 24 hours before, during, and after installation. All surfaces to be glued must be clean, dry and free from irregularities. Remove all paint, varnish, grease, oil, dust, sawdust and other foreign materials. Pre-fit parts before applying adhesives.

Application : Apply an uniform coat of glue to both surfaces using a soft brush, short nap roller or spray gun. Porous surfaces such as trim strips may require two coats. Allow to dry 20 to 60 minutes until the film is matte (indicates sufficient coverage) and tacky (similar to duct tape).

Within the next 18 hours, place both surfaces in exact position and join them carefully. The bond is instant on contact and surfaces cannot be repositioned. Using a metal roller or a rubber mallet apply firm pressure over entire area, working from the centre toward edges to eliminate any air pockets.

Roll in two directions at 90° angles to each other. Adhesion strength will increase with aging, but edges can be cut for finishing immediately. Let cure at least three days before exposure to direct sunlight or high temperatures.


Category Glues
Brand Dura Pro
Sold Since January 14, 2013

Approx: 9 m \2 / L.


< 50 g / L


Mild ammonia odor


Keep container closed between uses and store off the floor at room temperature. Shelf life is 1 year at room temperature in original unopened container. The poduct is freeze/thaw stable if frozen not lower than -10°C.

Tools cleaning

Clean tools immediately after use with warm soapy water. If dried, use mineral spirits.


Aqua green

Customers who bought this item also bought


There is currently no review for this product. Be the first to submit one!


Terms of Sales · Privacy · En français