• Stir thoroughly before use.
• Apply in light, even coats of 3-4 wet mils.
• Always scuff sand previous coat with 320 grit sand paper and remove any sanding dust from the surface before applying any additional coats.
• Apply appropriate sheen of the desired type of Mohawk Waterborne topcoat.
• Total finishing system, including primer and topcoats, should not exceed 4 dry mils. Waterborne sealers and finishes are high solids, quick building products.
  Excessive finish build can lead to a cloudy finish especially in lower sheens, cracking, cold checking and other finish failures.
• Waterborne White Primer may be tinted not to exceed 10% addition by volume.

Notes:

• Protect from Freezing.
• Waterborne White Primer is provided at a ready to spray viscosity. Small amounts of water may be added if further reduction is needed.
• Stainless steel equipment is recommended.
• Flush equipment and fluid lines after use with warm tap water.
• Do not use a tack cloth to remove sanding dust. Dust should instead be removed with a dry cloth or compressed air.