Preparation:

Sand raw wood with #120-#150 and finish with no finer than #220. Over stained wood allow stain to dry 12-24 hours before applying topcoat.

Application:

• Stir well prior to use.
• Apply Arm-R-Seal with a clean cloth (old t-shirts work well). For large flat surfaces a foam brush or paint pad applicator works best.
• Apply thin to moderate coats. Using the same wet applicator, wipe out the excess evenly with the grain using long smooth strokes.
• Three coats are recommended. A common problem is to put too much pressure on the applicator when wiping out the excess. The pressure can cause a friction streak which shows up after drying. These streaks may easily be removed by buffing or sanding well and recoating.
• Between coats buff with ‘0000’ steel wool, #320 sandpaper or superfine sanding pad to produce a smooth surface. Do not buff final coat..

Drying Time:

Good drying conditions 6-8 hours. Cold or damp conditions, up to 24 hours.

Coverage:

350 sq. feet per litre