LiquidWood Epoxy Wood Consolidant by Abatron

06:21

Abatron LiquidWood® and WoodEpox®

12:51

How To Repair WOOD ROT and Water Damage With ABATRON

03:13

Essential Repair - Eave and Rafter Tail Wood Repair

01:33

Learn the Basics - Mixing LiquidWood

01:06

Learn the Basics - Blending LiquidWood and WoodEpox

LiquidWood Epoxy Wood Consolidant by Abatron

LiquidWood strengthens decayed wood indoors and outdoors, structural and decorative. Use on buildings, boats, windows, columns, decks, and any wooden architectural elements. LiquidWood can also be used as a primer for WoodEpox®.

LiquidWood epoxy consolidant permanently restores structural strength and durability to rotted, decayed, or dried out wood.

LiquidWood penetrates deeply into wood fibers to solidify deteriorated wood without the need to remove and cut out the areas that can be effectively consolidated.

With LiquidWood, a piece of deteriorated wood that could crumble under finger pressure can be restored to rigid, high-strength, durable, water and weather-resistant wood.

Treated wood can be: sawed, planed, drilled, nailed, painted, routed, or sanded.

Penetrates and hardens rotted wood
Restores structural strength
Permanent
Easy application
Exterior/Interior

LiquidWood is usually used with WoodEpox, sold separately.

The Wood Restoration Kit including LiquidWood and WoodEpox is also available.

Documents

LiquidWood & WoodEpox Instructions Safety Data Sheet

Directions for Use

Important: The practical application temperatures are above 50°F (10 °C). The preferred temperature range is 60-90°F (16 à 32 °C).

Apply to clean and dry surface after removing contaminants, oil, grease,
wax, old paint and debris.
Mix a volume of LiquidWood A with an equal volume of LiquidWood B for at least one minute with blade or paddle.
Apply LiquidWood mix to deteriorated wood by brushing, pouring or injecting.
For deeper penetration into wood, drill small holes through side grain and across end grain, and pour LiquidWood into holes. Repeat process until wood is saturated.
Mix thoroughly a volume of WoodEpox A with an equal volume of WoodEpox B.
Apply WoodEpox to wood primed with LiquidWood while LiquidWood is still "tacky" to fill cracks, holes and replace missing wood.
Sand, plane, shape, paint and stain restored wood as desired.

Variants

354 ml (2 x 177 ml) LWAB60R	$36.91	In stock
1 L (2 x 500 ml)	$74.15	In stock
7.58 L (2 x 3.79 L) LW2GKR	$305.77	In stock

Specifications

Classification	Epoxy Resins for Wood Wood Restoration
Brand	Abatron
Sizes	354 ml (2 x 177 ml) 1 L (2 x 500 ml) 7.58 L (2 x 3.79 L)
Sold Since	April 2, 2020
VOCs	0 g / L
Origin	USA
Storage	LiquidWood and WoodEpox can be stored at least 1 year and almost indefinitely. Store in a warm area in containers with tight-fitting lids. To check old products, mix a small volume and observe whether it hardens properly.
Solids	100%
Pot Life	30 minutes
Application Temperature	The practical application temperatures are above 50°F (10 °C). The preferred temperature range is 60-90°F (16 à 32 °C).