DIRECTIONS:

• Stir thoroughly before using, do not shake.
• Sand raw wood with 180-220 grit sandpaper just prior to applying the sealer.
• Apply EnduraGreen Waterborne Exterior White Sealer in light, even coats of 3-4 wet mils.
• Always scuff sand previous coat with 320 grit sandpaper after 2 hours of dry time. Remove any sanding dust from the surface before applying any additional coats. Total finishing system, including sealer and topcoats should not exceed 5 dry mils.
• EnduraGreen Waterborne Exterior White Sealer is manufactured at spray viscosity. Small amounts of clean water may be added if further reduction is necessary. Begin with 1 ounce per gallon and add additional water if necessary. Do not exceed 5%.
• Strain product before use for best results. Stainless steel spray equipment is recommended to avoid contamination (discoloration). Flush equipment and fluid lines after use with warm tap water.

• This product can be used both indoors and outdoors.

• Do not use a tack cloth to remove sanding dust. Sanding dust should be removed with a dry/ damp cloth or compressed air.