Surface preparation
Remove the dirt from the greyed wood with a broom. Afterwards wet the surface with water. Wood Reviver Power Gel is a ready-to-use product, do not thin. Before the treatment with the Wood Reviver Power Gel please check the surface (trial application is recommended)!
Application
Apply the gel in the direction of the wood grain. Wait for approximately 20 minutes, clean with a hard brush and rinse with plenty of water. After approx. 48 hours drying time, protect the now fresh-looking wood permanently with a finish (e.g. Osmo Wood Oils or similar).
Coverage
Approx. 10 m² with one coat per litre The coverage of the product depends significantly on the character of the timber. All information refers to smooth and planed/cut surfaces. Other surfaces may lead to another coverage.
Note
Protect metals (e.g. fittings) and plants against direct contact (e.g. cover useful – and ornamental plants with painters film).
Storage
Do protect against frost and do not store in locations with higher temperatures (best storage temperature 5-30 °C).
Keep out of the reach of children. Avoid contact with eyes and skin. In case of contact with eyes, rinse immediately with plenty of water and turn to a doctor. Wear protective clothing, protective gloves and eye protection/ face protection while using. In case of swallowing seek medical advice immediately and show the container or label.
