Surfaces should be clean, dry, sound and free of dust, dirt, excessive chalky material, grime, grease, oil, wax, mildew, wallpaper adhesive or any contamination that may interfere with adhesion. If unsure, always wash surface with appropriate cleaning solution, ammonia and water or solvent (Do not use TSP). Remove unsound coatings. For exterior spot priming, sand exposed wood to remove weathered wood fibers. For stain killing, attempt to remove as much of the stain as possible. Kill and remove any mildew.
- Shake or stir before using
- Eliminate all sources of ignition.
- Brush, roll oor spray. Follow spray equipment manufacturer's instructions. DO NOT THIN.
Airless spraying - .011" to .013" tip at 800-1200 P.S.I. Wear a NIOSH approved respirator and provide adequate ventilation. Apply between -18 and 32 degrees Celcius, relative humidity below 85%, and surface temperature 9 degrees C over dew point.
Tinting: Tint with up to 16 ml of universal colourant per liter. Tinting primer helps topcoat hide in 1 coat.
Approx. 11.8 sq. m per 946 ml, or 47 sq. meters per gallon, depending upon application method and porosity.
Approximately 15 minutes to touch, 45 minutes to recoat.
Not recommended for full surface application on exterior substrates, floors, decks, patios, porches, excessively humid interior areas or surfaces subject to immersion or prolonged contact with water.