The pad protector disc is designed to protect the backing pad from wear and tear, when sanding aggressively and continuously with Mirka's Net products.
This cost effective pad protector, placed between the backing pad and the sanding disc, should be changed regularly. The pad protector prolongs the life of the backing pad.
The 5 inch (33 holes) pad protector can be used with most 5 inch (8 holes) sanding pads.
When a pad saver or interface is used for sanding, the set-up may increase the level of vibration. Your Mirka tool has a feature allowing you to reduce this vibration. To reduce vibration when a pad saver or interface is being used, please follow these steps:
1. Disconnect power cable.
2. Remove backing pad.
3. Add hex nuts and screws in accordance with the table below, tighten to 2 Nm.
There is currently no review for this product. Be the first to submit one!
Be the first to know about our new products and sales.
Terms of Sales