Pad Protector by Mirka

5/5 · 3 reviews

00:48

Using the Mirka Pad Saver

01:49

This is Mirka

Pad Protector by Mirka

5/5 · 3 reviews

The pad protector disc is designed to protect the backing pad from wear and tear, when sanding aggressively and continuously with Mirka's Net products.

This cost effective pad protector, placed between the backing pad and the sanding disc, should be changed regularly. The pad protector prolongs the life of the backing pad.

The 5 inch (33 holes) pad protector can be used with most 5 inch (8 holes) sanding pads.

Documents

Catalog

Reducing vibrations when sanding with pad protector

When a pad saver or interface is used for sanding, the set-up may increase the level of vibration. Your Mirka tool has a feature allowing you to reduce this vibration. To reduce vibration when a pad saver or interface is being used, please follow these steps:

1. Disconnect power cable.
2. Remove backing pad.
3. Add hex nuts and screws in accordance with the table below, tighten to 2 Nm.

Variants

2 units · 5" Disc 9955RP	$28.62	In stock
2 units · 6" Disc 9956RP	$31.80	In stock
5 units · 5" Disc 99528	$39.22	In stock
5 units · 6" Disc 9956	$46.64	In stock