Waterborne Wood Tone Sealer by Mohawk

Mohawk Waterborne Wood Tone Sealer has a slight amber cast that adds warmth and richness to stain colors similar to a solvent based sealer look.

Waterborne Wood Tone Sealer may be used as a sanding sealer for both Waterborne Pre-Catalyzed or Waterborne Conversion Varnish topcoats.

No catalyst is needed and it is ready to spray from the can. Waterborne Wood Tone Sealer is not recommended over white or other opaque colors.

Low odor, water clean up
Easy to apply, dries quickly
High solid content
Self-leveling
Mild, non-annoying odour

For Professional Use Only

Documents

Technical Data Sheet Safety Data Sheet

Directions for Use

Preparation

Stir thoroughly before using.

Application

Apply Waterborne Wood Tone Sealer in light, even coats of 3-4 wet mils. Always scuff sand previous coat with 320 grit sand paper and remove any sanding dust from the surface before applying any additional coats. Apply appropriate sheen of the desired type of Mohawk Waterborne topcoat.

Total finishing system, including sealer and topcoats, should not exceed 4 dry mils. Waterborne sealers and finishes are high solids, quick building products. Excessive finish build can lead to a cloudy finish especially in lower sheens, cracking, cold checking and other finish failures.

Waterborne Wood Tone Sealer may be tinted with Mohawk Waterborne not to exceed 10% addition by volume.

Specifications

Classification	Wood Lacquers
Brand	Mohawk
Sold Since	September 30, 2019
Coverage	130 sq. ft. / L
VOCs	179 g / L
Origin	USA
Dilution	Water as needed
Tools cleaning	Soapy water
Color	Amber
Solids	57 %