Stir thoroughly before using, do not shake.
Apply EnduraGreen Acrylic Sealer in light, even coats of 3-4 wet mils. Always scuff sand previous coat with 320 grit sandpaper and remove any sanding dust from the surface before applying any additional coats. Total finishing system, including sealer and topcoats, should not exceed 4 dry mils. Waterborne sealers and finishes are high solids, quick building products. Excessive finish build can lead to a cloudy finish especially in lower sheens, cracking, cold checking and other finish failures.
EnduraGreen Acrylic Sealer may be tinted with Waterborne Colorants not to exceed 10% addition by volume.
Protect from freezing. If product has frozen and appears unusable, place product at room temperature (minimum 70 degrees F) for 48 hours then add 1% water by volume to reduce viscosity.
EnduraGreen Acrylic Sealer is manufactured at spray viscosity. Small amounts of clean water may be used if further reduction is necessary. Begin with 1 ounce per gallon and add additional water if necessary. Do not exceed 5%.
Strain product before use for best results.
Always use a Mohawk Waterborne Sealer under lower sheens (40 or below) in order to reduce the risk of cloudy looking film that is sometimes caused by excessive build of lower sheen coatings.
Always do a sample panel to test results of mixture prior to applying on the actual work.
Remove sanding dust after sanding.
Stainless steel spray equipment is recommended to avoid iron contamination (discoloration).
Flush equipment and fluid lines after use with warm tap water.
Do not use a tack cloth to remove sanding dust. Sanding dust should be removed with a dry cloth or compressed air.
FIRST AID - EYE CONTACT: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.
FIRST AID - SKIN CONTACT: IF ON SKIN: Gently wash with plenty of Soap and Water. If skin irritation occurs: Get medical advice/attention.
FIRST AID - INGESTION: IF SWALLOWED: rinse mouth. Do NOT induce vomiting. IF exposed or if you feel unwell: Call a POISON CENTER or doctor/physician.
FIRST AID - INHALATION: IF INHALED: If breathing is difficult, remove victim to fresh air and keep at rest in a position comfortable for breathing. IF exposed or if you feel unwell: Call a POISON CENTER or doctor/physician.