DIRECTIONS:
Stir thoroughly before using, do not shake. EnduraGreen Waterborne Exterior Urethane Clear may be used as its own sealer and over EnduraGreen Waterborne Exterior White Sealer or EnduraGreen Waterborne Exterior Urethane White. If sealer is used allow 60 minutes to dry before sanding with 320 grit sandpaper. If applying to raw wood, sand with 180-220 grit sandpaper just prior to applying the coating.
Apply EnduraGreen Waterborne Exterior Urethane Clear in light, even coats of 3-4 wet mils.
Always scuff sand previous coat with 320 grit sandpaper after 2 hours of dry time. Remove any sanding dust from the surface before applying any additional coats. Total finishing system, including sealer and topcoats should not exceed 5 dry mils.
EnduraGreen Waterborne Exterior Urethane Clear is manufactured at spray viscosity. Small amounts of clean water may be added if further reduction is necessary. Begin with 1 ounce per gallon and add additional water if necessary. Do not exceed 5%.
Strain product before use for best results. Stainless steel spray equipment is recommended to avoid contamination (discoloration). Flush equipment and fluid lines after use with warm tap water.
This product can be used both indoors and outdoors.
Do not use a tack cloth to remove sanding dust. Sanding dust should be removed with a dry/ damp cloth or compressed air.
