Mixing Instructions:
In a clean, dry container; combine (by volume) 2 parts resin with 1 part hardener, and mix thoroughly for 5 minutes. Add color pigments or metallic pigments as desired and mix until evenly disperesed.
Application Instructions:
Working area should be clean, dry, and free of dust and insects. FlowCast can be poured 12-38 mm thick (1/2" - 1.5") per layer. The chemical reaction of curing epoxy releases heat - For pours of 12L volume or more, multiple thinner layers/pours may be necessary to prevent overheating. Fans blowing across the curing epoxy are also strongly recommended to help dissipate heat.
- For best adhesion between layers, wait 25 - 48 hours between pours (until the previous layer has set but is still tacky). If the previous layer is no longer tacky, sand with 220 grit sandpaper and wipe down before pouring another layer.
- FlowCast will not shrink while curing under normal conditions. However, it may slowly fill cracks and voids in your mold, causing the level to drop. Be prepared to add more epoxy as needed.
