Application Guidelines
- Application Temperature: Above 10°C
- Open Assembly Time: 15 minutes (21°C./50% RH)
- Total Assembly Time: 15-20 minutes (21°C./50%RH)
- Minimum Required Spread : Approximately 6 mils or 250 square feet per gallon
- Required Pressure Application : 100-250 psi, depending on substrates
- Method of Application: For most consistent coverage a mechanical spreader is recommended.
- Cleanup: Damp cloth while glue is wet. Scrape off and sand dried excess.
Bond Strength ASTM D-905 (On Hard Maple)
- At room temperature: 2,508 psi (6% Wood Failure)
- 66°C overnight: 656 psi (0% Wood Failure)
Limitations
Titebond Cold Press for Veneer is specifically designed for veneering and is not suited for other types of assembly applications. Not recommended for exterior use or where moisture is likely. Do not use when temperature, glue or materials are below 50°F. Freezing may not affect the function of the product but may cause it to thicken. Agitation should restore product to original form. Read MSDS before use. NOTE: STIR PRODUCT BEFORE USE TO ENSURE UNIFORMITY. KEEP FROM FREEZING.
CAUTION: EYE AND SKIN IRRITANT. Contains oxydipropyl dibenzoate. Do not swallow. Do not allow eye contact or prolonged skin contact. FIRST AID: If swallowed, do not induce vomiting, contact physician. If eye contact occurs, flush eyes with water for 15 minutes. Wash skin contact areas with soap and water. If irritation from eye or skin contact persists, contact physician. For additional information, refer to Safety Data Sheet. KEEP OUT OF THE REACH OF CHILDREN.
