Aqua Play 1 by Vermeister

Vermeister Aqua Play 1 is a single component waterborne floor finish featuring considerable ease of application and an excellent flow resulting in floors with an impeccable appearance.

Thanks to the S-XL technology, Aqua Play 1 has good resistance to abrasion, scratching, scuff marks as well as chemical resistance equal to two component systems. If it is also used as a sealer, it confers a particularly warm tone to the wood.

Great ease of application
Good mechanical and chemical resistance
Toning effect (if applied directly on the wood)

For Professional Use Only

Documents

Technical Data Sheet Safety Data Sheet

Directions for use

Application

Before proceeding with the application, the surface must be treated with a Vermeister waterborne sealer. Alternatively, the product may be applied as a first coat. Stir the finish well and apply a first, even coat.

To guarantee the application is uniform, the first coat should be applied against the grain and then crossed and spread in the direction of the grain of the wood. After 4 hours the floor can be sanded with an abrasive 180-220 grit, vacuumed and then coated again with the same product.

Notes

The application of single component waterborne products on solvent based sealers and finishes may lead to separation if the sanding operation is carried out too lightly. In these cases, use of two component waterborne finishes from the Vermeister range is recommended.
If the product is used on exotic and/or little known woods, it is always advisable to carry out some preliminary tests as in some cases (e.g. on IPE LAPACHO) the application of waterborne products directly on the wood or on sealers that are not perfectly insulating, may cause a considerable reddening of the film.
Do not apply the product below 10°C or above 30°C.
Do not replace any leftover product in the container!
Stir well before use
Store above freezing
Product subject to the restrictions prescribed by EC Directive 2004/42.

Specifications

Classification	Wood Varnishes
Brand	Vermeister
Sold Since	February 22, 2018
Drying Time	Dust dry: 20 minutes Impression dry: 40 minutes Overcoating without sanding: After 1 hour, within 3 hours Dry for sanding: 4 to 6 hours Light traffic: 8 to 16 hours Careful use: 2 to 3 days Completely dry: 7 days
Coverage	100 to 130 sq ft per liter 400 to 500 sq ft per gallon
VOCs	70 g / L
Origin	Italy
Dilution	Water, max 10%
Shelf Life	12 months - In original, unopened containers stored in a cool, dry place
Tools cleaning	Water
Luster	X-Matt - 10° Satin - 30° Semi-Gloss - 60° Gloss - 90°
Maintenance	For the maintenance of the coated floors use only Detergente Neutro and/or Idornet. Do not use alcohol, ammonia or detergents for hard surfaces.
Tools	Microfiber roll 10 mm Flexible Poly Nylon Brush Spray gun with 1.3 or 1.4 mm nozzle
Freeze/thaw stability	Avoid too many freeze-thaw cycles. If the product has frozen, allow the product to thaw at room temperature for 48 hours without stirring.