Operations Status during COVID-19   View Message  

Timbermate Woodfiller by Timbermate

4.7/5 · 3 reviews
from $11.95
Free shipping
on orders over $90
Quebec, Ontario · More info

Timbermate Water-based Woodfiller is 4 in 1 interior grade Crackfiller, Edgefiller, Grainfiller and Woodputty. It can also be used as a sanding sealer when thinned slightly with water. Timbermate Woodfiller is non-flammable and non-toxic and will not sink, crack, shrink or fallout. Excellent products for luthiers who use it as wood filler.

Timbermate Woodfiller will accept nails, screws, sawing, drilling and routing. It mixes perfectly with oil or latex tints, dyes, and stains, so that custom colors can be accurately reproduced.

Timbermate is a water based product, and therefore does not contain any Acrylic, Latex or Solvents. Available in 13 premixed colours plus Natural Tint Base, Timbermate Woodfiller takes all types of known stains, varnishes and coatings. Timbermate Woodfiller will remain stable under freeze/thaw cycle, and has an unlimited shelf life: You can easily reconstitute the product if dry.

Colors

Colors shown are for information purposes only: Actual colors may vary from the color on your screen due to monitor differences.

Directions for Use

For Grain Filling (filled finish)

  1. MIX: If staining, use Timbermate Natural/Tint Base. Otherwise match the color to the wood. Mix Timbermate in the tub with warm water (a mixer attached to a heavy duty drill is ideal). Slowly pour the water in as you mix – Timbermate should have the consistency of thick paint. Allow Timbermate mixture to dry to the consistency of toothpaste before sealing tub.
  2. APPLY: Just before the final hard plate or screening, apply Timbermate by flooding the surface and squeegee it across the grain over the entire wood surface. Do not apply Timbermate too heavily – a small amount goes a long way. Remove all excess Timbermate (return excess to the Timbermate container-no waste).
  3. DRY: Let Timbermate dry thoroughly. Use a heat gun or similar to speed drying time if desirable. (Timbermate is properly dry if it sands to the consistency of baby powder.)
  4. SAND: Final hard plate or screen and remove all dust and debris. (NOTE: Do not use a grit coarser than 120.)
  5. STAIN: Apply stain to the wood (if staining).
  6. FINISH COAT: Apply any final finish coat.

For Spot Patching

  1. APPLY: If staining, use Timbermate Natural/Tint Base. Otherwise match the color to the wood. Using a plastic or high quality stainless steel putty knife, apply Timbermate to the wood surface directly out of the tub prior to the last sanding. (NOTE: If filler turns black, the putty knife is not high content stainless steel; however, the black will sand off.)
  2. FILL: If hole is greater than 1/4", fill by layering Timbermate in 1/4" increments.
  3. DRY: Let Timbermate dry thoroughly. Use a heat gun or similar to speed drying time if desirable. (Timbermate is properly dry if it sands to the consistency of baby powder.)
  4. SAND: Final sand and remove all dust and debris.
  5. STAIN: Apply stain to the wood (if staining).
  6. FINISH COAT: Apply any final finish coat.

For Trowel Filling:

  1. MIX: If staining, use Timbermate Natural/Tint Base. Otherwise match the color to the wood. Mix Timbermate in the tub with warm water (a mixer attached to a heavy duty drill is ideal). Slowly pour the water in as you mix – usually about 15% water by weight. Mix until Timbermate has the consistency of toothpaste.
  2. APPLY: Apply Timbermate, just before the final sand, with a plastic trowel, or rubber float across the grain over the entire surface. Make sure the filler is forced into deep voids. Do not apply Timbermate too heavily – a small amount goes a long way. Remove all excess Timbermate. (Return excess to the Timbermate container-no waste.)
  3. DRY: Let Timbermate dry thoroughly. Use a heat gun or similar to speed drying time if desirable. (Timbermate is properly dry if it sands to the consistency of baby powder.)
  4. SAND: Final sand and remove all dust and debris. (If grain filling do not use a grit coarser than 120.)
  5. STAIN: Apply stain to the wood (if staining).
  6. FINISH COAT: Apply any final finish coat.

Variants

250 g / 8 oz · Alder
ALD25
$11.95 In stock
250 g / 8 oz · Bazilian Cherry
ABC25
$11.95 In stock
250 g / 8 oz · Cherry
BB25
$11.95 In stock
250 g / 8 oz · Chestnut
AC25
$11.95 In stock
250 g / 8 oz · Ebony
AE25
$11.95 In stock
250 g / 8 oz · Mahogany
AAM25
$11.95 In stock
250 g / 8 oz · Maple / Beech / Pine
AMB25
$11.95 In stock
250 g / 8 oz · Red Oak
ARO25
$11.95 In stock
250 g / 8 oz · Tasmanian Oak
TAO25
$11.95 In stock
250 g / 8 oz · Teak / Heart Pine
AAC25
$11.95 In stock
250 g / 8 oz · Tint Base / Natural
ATB25
$11.95 In stock
250 g / 8 oz · Walnut
AW25
$11.95 In stock
250 g / 8 oz · White
AWH25
$11.95 In stock
250 g / 8 oz · White Oak
AWO25
$11.95 In stock
4 lbs / 2 kg · Alder
ALD2
$34.95 In stock
4 lbs / 2 kg · Bazilian Cherry
ABC2
$34.95 In stock
4 lbs / 2 kg · Cherry
BB2
$34.95 In stock
4 lbs / 2 kg · Chestnut
AC2
$34.95 Out of stock
4 lbs / 2 kg · Ebony
AR2
$34.95 In stock
4 lbs / 2 kg · Mahogany
AAM25
$34.95 In stock
4 lbs / 2 kg · Maple / Beech / Pine
AMB2
$34.95 In stock
4 lbs / 2 kg · Red Oak
ARO2
$34.95 In stock
4 lbs / 2 kg · Tasmanian Oak
TAO2
$34.95 In stock
4 lbs / 2 kg · Teak / Heart Pine
AAC2
$34.95 In stock
4 lbs / 2 kg · Tint Base / Natural
ATB2
$34.95 In stock
4 lbs / 2 kg · Walnut
AW2
$34.95 In stock
4 lbs / 2 kg · White
AWH2
$34.95 In stock
4 lbs / 2 kg · White Oak
AWO2
$34.95 In stock
16 lbs / 8 kg · Ebony
AR8
$81.95 Out of stock
16 lbs / 8 kg · Maple / Beech / Pine
AMB8
$81.95 In stock
16 lbs / 8 kg · Red Oak
ARO8
$81.95 In stock
16 lbs / 8 kg · Tint Base / Natural
ATB8
$81.95 In stock
16 lbs / 8 kg · Walnut
AW8
$81.95 In stock

Specifications

Classification Wood Restoration
Brand Timbermate
Sizes
  • 250 g / 8 oz
  • 4 lbs / 2 kg
  • 16 lbs / 8 kg
Sold Since March 27, 2014
Composition

Water, Soluble Non hazardous mineral filler, Insoluble Non Hazardous mineral filler

VOCs

0 g / L

Origin

Australia

Dilution

Water

Aspect

Colored Paste

Conservation

Timbermate Woodfiller will remain stable under freeze/thaw cycle, and has an unlimited shelf life: You can easily reconstitute the product if dry.

Tools cleaning

Water

Similar products

Complementary products

Review

Very nice

Andre Marques · Feb 5, 2020

My favourite

Timber Mate

Darryl Turner · Feb 10, 2019

Awesome product. I will never use another.

Great

Scott Murphy · Feb 22, 2016

Great water based Product, easy to use. Worked great as grain filler when mixed with a little water. Its non toxic and doesn't have a chemical smell but WOW is it smelly...smells like a cows butt!

          

Terms of Sales · Privacy · En français